View Single Post
Old 02-09-2013, 05:49 AM   #139
England-Kev OP
Beastly Adventurer
 
Joined: Feb 2007
Location: England. Somewhere on the Canal.
Oddometer: 3,494
This is a general question to the long term owners of the V7 series engines, on the airhead boxer BMW engines, BMW changed the specified clearences of the tappets (valves) from the original spec to a smaller spec. Now I find the tappets noisy on the V7, this maybe because the valve boxes are out in the open and up near the rider, but I wondered if any of you had run the exhaust valves at a smaller than specified clearence?
The book says inlet at 0.15mm and exhaust at 0.25mm, but I wondered how it would run at .15mm and .20mm ?

England-Kev screwed with this post 02-09-2013 at 06:53 AM Reason: spelling
England-Kev is offline   Reply With Quote