View Single Post
Old 02-10-2013, 05:10 AM   #10
schattat OP
Beastly Adventurer
 
schattat's Avatar
 
Joined: May 2008
Location: Frankfurt am Main, Germany
Oddometer: 1,413
Here some additional parts installed.

Íhlins rear shock with harder spring rate, borrowed from dad for the event:


Clutch cover protection (the walls are very thin). Just to be on the safe side:


Tall bar risers:


ProGrip 786 rallye grips:


Motomaster 270mm disc adapter. With some careful geometry I drilled and tapped two M8 holes to fit the sensors of the TripMaster:


Front mounts to fit the bash plate (original Yamaha rallye kit parts). Again, borrowed from dad. I was planning on designing and fabricating my own one. The space between these two parts is big enough to make a compartment. Lack of time means I will have to do it sometime later:
__________________
RNS - Rallye Navigation Solutions

Yamaha WR450F Rallye Spec
schattat is offline   Reply With Quote