View Single Post
Old 02-11-2013, 08:04 AM   #24870
Flashman1
Beastly Adventurer
 
Flashman1's Avatar
 
Joined: May 2006
Location: Tucson
Oddometer: 5,356
Quote:
Originally Posted by BiG DoM View Post
Definitely makes a difference - problem can start with where the actuating arm is adjusted for the start of the pull but this cannot be adjusted without dropping the oil and removing the side cover and adjusting the nut on the rod. The plate can be tweaked for better alignment and you can also look at the ferule at the hand lever and slop there - can be taken up quite simply with a small strip of shimstock wound round the tip of the cable which is a thinner OD than the lever ferule (some have actually turned an additional sleeve piece but not really necessary - see on Cafe Husky)
Shim stock?
Flashman1 is offline   Reply With Quote