View Single Post
Old 02-12-2013, 07:45 AM   #73841
Rusty Rocket
Life behind "Bars"
 
Rusty Rocket's Avatar
 
Joined: Dec 2005
Location: Northcentral CT
Oddometer: 8,252
Quote:
Originally Posted by spotlight View Post
So then your saying check the chain slack with the bike loaded? And I have owned mostly dirt bikes had an XT-250 before this bike....
The chain will be tightest when the three pivots line up in a straight line

The countershaft, the swingarm shaft and the rear axle. If you can compress your suspension to that point and verify there is still a bit of slack you'll know you have it right. Then release the suspension and see what it needs to be when the suspension is unloaded and make a mental note or take measurements


1 First of all, the chain must be placed at its maximum tension condition. This condition will occur whenever the engine and wheel sprockets are at the maximum distance from each other.

To obtain this, it is generally necessary to load the back wheel (for example placing a person on the motorcycle) until the centers of the engine sprocket, the swingarm pivot and the rear wheel axle have been positioned on the same axis. The swinging arm will be parallel to the ground.

http://www.reginachain.it/eng/use_an...how_to05.shtml
__________________
In the beginning, there was nothing. Even That exploded
2009 DR650
..1972 Penton Six-Days ..1971 Suzuki TS185.. 2005 KTM 400exc
Member of: AMA, NETRA, Blue Ribbon Coalition, CCCofVT, Berkshire TR, CT Ramblers
Rusty Rocket is online now   Reply With Quote