View Single Post
Old 02-15-2013, 03:56 AM   #29
JRWooden
Beastly Adventurer
 
Joined: Jul 2008
Location: The great state of confusion
Oddometer: 4,117
I believe the Burnsmoto switch works by installing a switch in the wiring from the rear wheel sensor to the ABS control unit. The connector where it taps in is under the seat near the diagnostic plug. (Check the install instructions on the Burns site for details & to make sure I am correct on this)....

If so as a quick check you could simply unplug that connector under the seat (bike turned off of course).

On a normal bike this would register a fault with the ABS computer at next power-up, and the ABS computer would then DISable the ABS system since it needs both wheel sensors to be working for it to do its ABS magic....
JRWooden is offline   Reply With Quote