View Single Post
Old 02-17-2013, 07:35 AM   #53
LaurelPerryOnLand OP
Beastly Adventurer
 
Joined: Jun 2009
Location: Denver, CO
Oddometer: 3,258
Quote:
Originally Posted by tommyvdv View Post
looking through the thread again I think I'm asking the same questions as @motorman.

I'm sorry if I was unclear. I'm trying to figure out exactly how and which parts were used to mount the pack to the inside of the r1200gs adventure rack.

but now I can't find the picture I was talking about.
HOW:
Attach a plate (as shown in the picture above in Post #48) between the upper and lower arms of the rack.
Attach the standard RotoPax mounting handle Post #42 (facing inwards) to the just installed plate.

PARTS:
Fabricate a custom plate for the adventure rack.
Use the standard RotoPax mounting handle.

NOTE: Make sure that when you order your RotoPax that you get VENTLESS paxs...otherwise you'll have a VENT on the BOTTOM which can leak.
Also...DO NOT USE THE SET UP ON THE LEFT (MUFFLER) SIDE...a leak of any kind near the muffler and you'll have a serious fire potential.
LaurelPerryOnLand is online now   Reply With Quote