View Single Post
Old 02-19-2013, 07:10 AM   #2
TINK OP
Studly Adventurer
 
Joined: Nov 2007
Location: So Cal
Oddometer: 650
End Seal

Now that I have the master apart, again, I think the problem with the steel ring on the end seal that is press fit into the master was that it was on backwords.
Looking very closely at the original one I noticed there is a tapper to one end, the end that slides into the master.
The steel ring on the new end seal was backwards when I tried to press it in, and subsequently bent it slightly out of shape doing so.





TINK

TINK screwed with this post 02-19-2013 at 07:27 AM
TINK is offline   Reply With Quote