View Single Post
Old 02-19-2013, 05:34 PM   #74050
Beastly Adventurer
BergDonk's Avatar
Joined: Nov 2010
Location: Snowy Mountains Oz
Oddometer: 3,925
Originally Posted by Adv Grifter View Post
No ... never saturate the filter. I simply drizzle on the sticky Foam filter oil, then work it into the filter with a rag, gently squeezing the filter until the oil is distributed evenly. You DO NOT need a lot of oil.

What's MORE important ... is putting a bead of GREASE along the sealing edge of the filter where it contacts the Air Box. This will prevent both dirt and water from getting into the Carb and motor.

Filter Cleaning 101 (YMMV)
1. Carefully remove dirty filter from air box, don't let crap around filter into Intake tract.
After removing filter ... clean air box well.

2. Immerse Filter into odorless Kerosene. Use rubber gloves and work Kero
into filter, wringing gently to break down former oil and dirt. Wring most of Kerosene out .. but DO NOT damage filter.

3. Insert filter into HOT water and Dawn dishwashing soap. Wash and ring out gently, then RINSE very well. Wring gently and put out in Sun or inside to dry before re-oiling.

4. Re-oil and install. (don't forget grease bead on sealing edge.

Lots of variations on this of course. Some use Dish soap alone. Some use Gasoline (), or Diesel. (stinks) Gasoline is dangerous and will break down the glued seams in your filter and destroy the foam over time.

Diesel will do the same over longer time. Kerosene seems fairly harmless to the foam with brief immersion and gets filter clean more quickly than Dawn alone. YMMV. IMHO, blah Blah Blah.
I use mineral turpentine, or turps, on Uni Filter's recommendation for cleaning, and no soap or water. Just clean with 'turps' and allow to air dry. There will be some residual oil left in the filter, so you don't have to add as much to reoil.
shed time IS quality time
BergDonk's DR650 BergDonk's XT1200Z
BergDonk is online now   Reply With Quote