View Single Post
Old 02-23-2013, 04:32 PM   #33350
KansasBob
Studly Adventurer
 
KansasBob's Avatar
 
Joined: Apr 2008
Location: Topeka
Oddometer: 515
Quote: What's recommended to clean the old bearings prior to regreasing if they are not replaced?
I later found this link that explains quit a bit about that "plastic stuff" http://www.thumperfaq.com/swingarm.htm

WOW! That is exactly the information I wanted.
Permanent Lubricant..... OK If you say so.
I'm comfortable with my decision to go old school, and pack her tight with water proof grease.

I'm back together, and torqued now. 47 rear, new seal guard, (third one from new) and a new chain is on. New Gel battery, a little fuel, and actually started

KansasBob screwed with this post 02-23-2013 at 04:49 PM
KansasBob is offline   Reply With Quote