View Single Post
Old 02-24-2013, 07:41 AM   #7
PackHorse OP
2012GS800Trophy
 
Joined: Feb 2013
Location: Williamsburg, Virginia
Oddometer: 3
Quote:
Originally Posted by ebrabaek View Post
Then you must have bumped something. You mentioned throttle bodies in plural, so I am assuming you pluged then directly, not after the purge valve, with just one plug. That is the only thing that would make the engine misbehave. Did you just take off the two side plastic triangles to plug both manifolds...... At this point..... I would retrace my steps, and investigate.

I did remove both triangles and plugged both throttle bodies directly, I've done this on several other bikes and everything worked fine, I'm in the process of checking to see if I did bump or disconnect something I should'nt have but I'm on my way out of town today so it will have to wait till next week. Just wanted to check to see if there was something I missed, thanks for the reply.
PackHorse is offline   Reply With Quote