View Single Post
Old 02-24-2013, 10:35 AM   #7466
Bill the Bong
Supern00ba
 
Bill the Bong's Avatar
 
Joined: Dec 2006
Location: Kalahari South Africa
Oddometer: 789
Need some ideas

I'm busy fitting the RR Evo 2 kit. After getting the principle bits fitted, I took it for a shake-down run. Everything was fine. Today messed around with getting the headlight aligned, getting fairings to fit and cleaned up the cockpit wiring.

When I wanted to take it for a run this evening, it started and idled fine. When I opened the throttle, it would either bog or flame out. It is possible to pick up revs when I open the throttle very slowly. Wicking it at any RPM causes a flame-out. It has fuel and no errors are display. All fuses OK.

Any ideas? I'm keen not to un-install everything.
__________________
KTM 690 R - "Its just a little crush..."
Bill the Bong is offline   Reply With Quote