View Single Post
Old 02-24-2013, 07:12 PM   #7472
thorinoakenshield
ya mo be there
 
thorinoakenshield's Avatar
 
Joined: Dec 2011
Location: ☼
Oddometer: 446
Pissed Rear wheel spacer on sprocket side srsly pissing me off!

What's the deal with the rear wheel spacers on the sprocket side?
I had this problem before, and I kind of ignored it. Now, I'm chaning my rear tire again and I was determined to remove the leftmost spacer.
What a pain in the ass! I had to bang it out with a screwdriver and aluminum rod. I marred the spacer all up to holy hell!!



Whoops....not a big deal,really.....


Why was I so determined? I wanted to see how effed my bearing where.
They're ok, thankfully, but I did find some RUST!! Most bike aren't lubed for shit from the factory, and this bike is no exception....






Dammit. Atleast the bearings spin fine....
So then I greased those spacers up with some marine grease and attempted to stick them back into the sprocket hub.
It's a tight fit! What the hell?! I had to tap them in with a mallet kind of hard!!! This seems really weird. The spacers have always slid in and out for every bike I've had, including another KTM.
Is that what everybody else has to do??!!
This means that for the next tire change, I'm going to have to go through all this crap again!!
It's such a tight fit, I'll have to struggle to get the spacers out again (even if I lubed them up)...for rust cleaning/bearing checking and re-lubing.
This is how I feel right now:

thorinoakenshield screwed with this post 02-24-2013 at 07:24 PM
thorinoakenshield is offline   Reply With Quote