View Single Post
Old 02-24-2013, 06:33 PM   #5
ebrabaek
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,507
You will need to take off the top plastic, so you can gain access to the nut. Most likely the bolt was cross threaded, and the nut is now spinning. You might need to retap the nut after you gain access. When you install the rack again. Begin all 4 bolts just a little before you Torque'em.
__________________


Erling
ebrabaek is offline   Reply With Quote