Originally Posted by IDRIDR
Question for ya. I have the rear wheel off my '06, trying to change bearings. The right (rotor) side spacer is stuck on there hard. This one isn't pressed into a bearing or anything, is it? Shouldn't it just lift off like the other spacers? Thanks.
Mine typically fall out via gravity. No, they aren't pressed. Should be a slip fit.
Here's hoping your bearings aren't that bad to cause the parts to seize/weld together.
"This place fucking runs on beer, you buy the right person a beer, and you get a job, a blow, a place to sleep, whatever.
You're hot, cold, thirsty, hungry... beer will fix that.
Beer is a god damn miracle, and don't you forget it!"