View Single Post
Old 02-25-2013, 10:25 PM   #86
BobLoblaw
Comfortably Numb
 
BobLoblaw's Avatar
 
Joined: Feb 2006
Oddometer: 1,471
Quote:
Originally Posted by dwj - Donnie View Post
I was wondering where I was going to get that glue. I actually removed the Hall Sensor about 17 months ago to check the wires, which were fine, the cup and the rotor were not glued together and I have had the moto since it had 28,000 miles.

I have been using SPOT, but I may be dropped, they say they can't use the Debit Card info I gave then to renew, and I know the info is correct. I will repost the link if SPOT is still tracking.

A lot a pretty women down here, but it is difficult to beat beauty and brains!

that probably contributd to the misalignment on re assembly. Just use some silicone to adhere the cup tp the pulley. After it sets reinstall the cup and pulley.. The clamp force of the pulley bolt will insure the assy stays put. The gluing does nothing more than help insure the cup and pulley do not get cocked upon reassy
__________________
Ride till you can't - Marty Hill
BobLoblaw is offline   Reply With Quote