View Single Post
Old 02-26-2013, 05:48 AM   #13
Ride4Coffee OP
Gnarly Adventurer
 
Ride4Coffee's Avatar
 
Joined: Jun 2012
Oddometer: 193
Quote:
Originally Posted by Hennepinboy View Post
If I recall properly the tread pitch on the bar ends is 1.25 threads per mm fine thread. 1.50 TPMM coarse thread appears to be the most common in the M12.

I am currently running a Kaoko throttle lock on a 08 R1200GSA and found the stock bolt long enough to secure the stock plastic hand guard using the aluminum bushing.
The stock bolt is:
32 71 7717802 COUNTERSUNK HEAD SCREW M12X1,5X80-MKL

I wonder if the 1.5mm is comparable to any other designated tpmm, like a DIN.

I figure the mounting part must be stuck down just a little too far.

The search continues...!

Ride4Coffee screwed with this post 02-26-2013 at 05:55 AM
Ride4Coffee is offline   Reply With Quote