View Single Post
Old 02-26-2013, 09:20 PM   #20
XSoCal OP
Gnarly Adventurer
 
XSoCal's Avatar
 
Joined: Jul 2012
Location: Calgary, AB
Oddometer: 189
Quote:
Originally Posted by Orangecicle View Post
After I saw this little video clip I ran out to figure out how to get the crossover line off of the top of the low fender: http://advrider.com/forums/showthread.php?t=667236

I saw that too...I've had two accidents on my R1 where I go over the bars, the last one they took me away in an ambulance strapped to a board, so not keen to have it happen again!

As far as the tansfer tube, I don't see the real advantage over a T fitting if the lines are the exact right length to run across the top of the lower triple right after the T. And if the banjo size is M10x1.0 for sure then it could be custom ordered for less than the 990 S split line.
XSoCal is offline   Reply With Quote