View Single Post
Old 03-02-2013, 07:02 PM   #14
supershaft
because I can
 
Joined: Sep 2010
Location: San Francisco Bay area
Oddometer: 8,835
IMO renewing the surface is mostly just going to get you that much closer to needing a bore job that much quicker. I have seen too many rings seat perfectly on untouched used bores. One thing is for sure, if by some odd chance the ring(s) doesn't seat after just replacing them, it only takes a few minutes to go back and do it differently. You might very well need a piston and/or bore job versus a hone job.
supershaft is offline   Reply With Quote