View Single Post
Old 03-08-2013, 05:32 AM   #357
HighTechCoonass OP
Living the Dream....
 
HighTechCoonass's Avatar
 
Joined: Jan 2005
Location: land of the swamps!, Cajun Country LA
Oddometer: 2,398
Laugh 1200 install of the Power Controller

15 minute install....
What you will receive after your purchase... (for all bikes)

Power Controller
Ty-rap and sticky base (for securing the external sensor)
A red decal and blue decal for easy switch position identification
Wukaking decal


When you receive you Power Controller play around with the connectors to understand how the BMW connectors work (lock and unlock).... pushing inwards on stainless wire to unlock the plugs...

The Install
1.Remove the left side panel
2 Locate the sensor (as shown in the below pictures)
3 Disconnect the factory wire from the sensor (push inwards on the locking wire and pull upwards to remove wire harness)
4 Connect the Power Controller between the factory wire harness and the factory sensor (in series)
5 Mount the Power Controller external temperature sensor (using the supplied tyrap and stick base) where it will not be effected by the bikes heat (in fresh air)
6 Mount the Power Controller selection switch where ever you prefer.
7 Proudly apply your "Wukaking Performance Products" decal in a prominent spot on your bike!! haha


























Quote:
Originally Posted by GSForLife View Post
Any installation pictures/instruction on a R1200GS year 08 & above?

Thanks.
__________________
Living the dream here in the good old USA! l

HighTechCoonass screwed with this post 04-17-2013 at 06:21 PM
HighTechCoonass is offline