View Single Post
Old 03-10-2013, 07:35 PM   #2679
Matified
been there done that
 
Joined: Aug 2010
Location: Utah
Oddometer: 108
Matified an updated mx fender

I purchased a few updated Maier MX style rear fenders to put on the KLXs,, the fender as delivered were for a 300, I ended up cutting two inches off the rear of the subframe and then made a few cuts to the front of the fender to move it forward a little bit, about an inch, this brings the part of the fender designed for the rear of the 300 seat closer to the rear of the 650 seat, not sure but I suspect the 300 seat is just a little longer at the rear. If I bolt the fender on and use the standard holes there is a gap between the seat and fender that puts it too far back and pointed to high. Just plain looks weird.
Here are a few pictures of the 93 and 96 to compare, I also did the conversion to the 96 shortly after. I think it look pretty good and adds a better tail light.










Matified is offline   Reply With Quote