View Single Post
Old 03-14-2013, 12:20 PM   #1955
kirkster70 OP
moto junkie
kirkster70's Avatar
Joined: Aug 2008
Location: Virginia
Oddometer: 1,905
Chop, chop.


More picture frames.

Clamp, clamp.

Square, square.

Checking for fit after tacking...

Weld towards mass, weld towards mass...GOT IT!


On my KLR bag lids like this, I also bent a reverse bend in this piece. The brake could do the short end easily, but not the long end - the apron felt like it wanted to spring, so I let off and finished the long ends by hammer forming on the vise.

This will get another flange welded to it for the "trap door" storage compartment. Still figuring things out as I go...

kirkster70 screwed with this post 03-14-2013 at 12:28 PM
kirkster70 is offline   Reply With Quote