View Single Post
Old 03-15-2013, 04:02 PM   #107
meijer's trails
Gnarly Adventurer
 
meijer's trails's Avatar
 
Joined: Jun 2008
Location: S.E. Michigan
Oddometer: 475
Hi dorkpunch,

I've got a similar 66 yj-2.
And I've been thinking 3d printing might be a good way to remake the intake snorkel joint from the case to the air filter.

There a few on eBay, but re-popping them the traditional way is going to cost like $400.

I'm wondering if 3d printing could print in Pliable rubber format?

Thoughts or ideas?
meijer's trails is offline   Reply With Quote