View Single Post
Old 03-18-2013, 05:51 AM   #21
rossguzzi
990 Adv.
 
rossguzzi's Avatar
 
Joined: Oct 2012
Location: Bottom left hand side of OZ
Oddometer: 712
I have a hunch it (in my case) could be wear on the pressure plate surface. We measure plates etc, but I can not find a measurement for the pressure plate. If it wears, then surely the thing will drag because it is not throwing out as far as it should. I have been toying with the idea of fitting a very thin shim washer on the end of the rod where it mates up to the bearing.
Any thoughts?
rossguzzi is offline   Reply With Quote