Originally Posted by Croissant Warrior
How did you mount your Pelican cases?
They're $65 Bunnings cases, they only have a batch of them every year or 2 though... I had them on my Dominator originally....
Thread about the cases>> http://www.advrider.com/forums/showt...=619341&page=7
The top case has a couple of alloy mounts on the front so it clips over the front of the B&B rack, there's 2x 6mm cap screws holding the back down at the moment, only takes a couple of mins to take off but I want to make a quick release, just haven't decided how to do it yet... (I'll probably move the case forward a bit and screw a bit of alloy angle on the back of the case which will slot into the rack.. hard to explain what I have in mind)
Post about topcase mounting>> http://www.advrider.com/forums/showp...0&postcount=10
The side cases are on an OTR rack ($230aus + del):
Using the OTR pannier mounting kit, ($62aus +del):
The OTR setup is pretty good value for money IMO, there's a bit more info here:
They've taken a bit of abuse:
(ran the left case up against a stump which pushed me over)