View Single Post
Old 03-23-2013, 01:47 PM   #41
Scootern29 OP
Gnarly Adventurer
 
Scootern29's Avatar
 
Joined: Sep 2012
Location: In the hot, hot, dezert
Oddometer: 478
Last Friday I put the trans back in the case to get ready to assemble them.



I ended up making a crank installation tool out of some steel pipe to pull the crank through the bearing instead of pounding on it.



After 45 minutes of assembling the cases, it took longer than I thought. Lining up the trans parts I thought would be the tough part. It wasn't. Pulling the crank through was a major PITA. All together.

Scootern29 is offline   Reply With Quote