Thread: KLR250 thread
View Single Post
Old 03-23-2013, 01:52 PM   #997
bigfishs
Adventurer
 
Joined: Oct 2007
Location: albany, NY
Oddometer: 46
Its unlikely any leds will flash properly without resistors. I put resistors in front and back but should have just done the flasher unit that goes under the tank. There is a thread here somewhere that talks about it. You can fit resistors in under the front light fairing and under the tool kit in the rear if you decide to go that route.

On a separate note, I love this forum. You guys are so freaking nice and helpful.
bigfishs is offline   Reply With Quote