View Single Post
Old 03-24-2013, 03:56 PM   #3416
kirkster70
moto junkie
 
kirkster70's Avatar
 
Joined: Aug 2008
Location: Virginia
Oddometer: 1,905
Quote:
Originally Posted by clintnz View Post
So I called in at a local engineering business that does a big variety of stuff & asked for a few lengths of 309L, the bloke said 'Nah mate, what you need is some MG600' So for a couple bucks I walked out with some of that. It seemed to lay in nicely considering my n00b skill level.



The butt welds on the rest of the tube with normal ss rods were nowhere near as pretty. I think I need to set up a purge on the inside to improve those.

Cheers
Clint
I think you are doing a fine job! Keep up the good work, Clint!
kirkster70 is offline   Reply With Quote