View Single Post
Old 03-25-2013, 05:34 AM   #25056
1 lunger
Beastly Adventurer
 
1 lunger's Avatar
 
Joined: Mar 2011
Location: Bloomfield CT
Oddometer: 1,188
Quote:
Originally Posted by jrusto View Post
Thanks for your response. I did pressure wash it since it was filthy from my shake down ride. I will check all the things you mentioned but how do I check fuel pump displacement. Dont know a lot about those things since I worked on simple 2 strokes. I would assume I would pull it off and turn the key on to see if it is spraying. Where is the best place to pull it apart to check.

Thanks again
Rusty
These things hate pressure washing!!! To many parts that don't like water!! Just drain the gas, put some fresh in and give it a go. It might take awhile. Pull the air filter too and see if its water logged. You can stray some WD-40 in the inner screen of the intake and let it drain out with the water if there's any. The filters are very susceptible to getting wet one these bikes! I never had any trouble until I started riding in the snow.
1 lunger is offline   Reply With Quote