View Single Post
Old 03-25-2013, 03:25 PM   #128
Mtl_Biker
Studly Adventurer
 
Mtl_Biker's Avatar
 
Joined: Jun 2011
Location: Montreal, Canada
Oddometer: 582
Thanks for the photos, Robbie. Can you tell where/what had to be ground out to make it fit?

Instead of using the supplied spacers which I think are too narrow, I bought a couple of stainless steel nuts that I'm going to use instead of the spacers. One of those is just about a hair thinner than both supplied spacers together. This way there would STILL be adequate play in the assembly.

I'm going to try to install the pegs tonight, but with no center stand it's a bit tough doing the left side.

Do you have a center stand? Mine (cut down, welded and painted) is due sometime this week. (Edit: Sorry, dumb question. I can see your center stand in the photos you posted.)
Mtl_Biker is offline   Reply With Quote