View Single Post
Old 03-29-2013, 04:14 PM   #71
TurkeyRun OP
Adventurer
 
TurkeyRun's Avatar
 
Joined: Nov 2012
Location: Central North Carolina, USA
Oddometer: 91
Quote:
Originally Posted by Mr Head View Post
yes:

Remove this cover,


Under it there is a cap screw that clamps the controls in place.
I don't have a picture of that.
The deed is done. Thanks! MUCH better.

For others, on my 2002 GSA:

Two torx and an allen to loosen the hand guard so it can be positioned out of the way

Three Phillips screws to remove that cover. One on the front, one on the bottom, one behind the mirror stem (much smaller than the other two). Remove the mirror stem with an Allen from the bottom.

That exposes the allen bolt, loosen, rotate, tighten

Put it all back together

Never having done it before, took me about 35 minutes to do both sides.

Sweet!

Dang, should have taken pics. If I have to adjust again, I will.

this board rocks
__________________
- 2012 XL1200C (Hers)
- 2002 R1150GSA (Mine)
- 2014 FLHTK (Ours)
- 2000 Ural Patrol (ummm... project?)
TurkeyRun is offline   Reply With Quote