View Single Post
Old 04-01-2013, 01:00 AM   #1
SamH OP
90S on the bench
 
SamH's Avatar
 
Joined: Aug 2005
Location: Tasmania, Australia
Oddometer: 434
Tiny oil seal in the input shaft

Hey guys, I keep reading about how to install the clutch push rod seal in the end of the input shaft but there doesn't seem to be any room for it on my shaft.

As best as I can tell my box is a '74, 5 speed, no kick start...

Is there a different setup for these boxes? The main part of the shaft is flush with the end of the top hat shaped bearing holder.
SamH is offline   Reply With Quote