View Single Post
Old 04-05-2013, 05:49 AM   #1923
jdrocks OP
Gravel Runner
 
Joined: Jul 2007
Oddometer: 3,929
Quote:
Originally Posted by yokesman View Post
03-04 636(clipons) both uppr,lower 50mm complete bolton,see ninja 650 forum
need additional work for bar clamps
05-08 z1000 uppers only 50mm, single bolt bar clamps-rubber mounted
i know the 49mm DRZ fork inners fit into the ID of these triples, i'm more interested in a centerline dimension of the clamps for comparison with the OEM Versys clamps. used z1000 clamps are available, but i didn't see anything cheap after a quick look, whereas the 636 clamps are easily found cheap.

50mm ID clamps just need a rolled formed sheet metal shim rather than a machined adapter for the 49mm fork tubes. easy enough, two sets for maybe $5.

so, if you have these triples, how about supplying a centerline dimension?


from his post in that linked thread, the builder clearanced the DRZ/DL setup so that the wheel could be mounted. i'm not sure how that's all going to work out.
jdrocks is online now   Reply With Quote