View Single Post
Old 04-06-2013, 03:04 PM   #43
Plaka
Brevis illi vita est
 
Joined: Jun 2010
Oddometer: 4,579
Quote:
Originally Posted by AirheadRick View Post
I liked the lok of the Rizoma bars and bought a set for my /7. They are labeled as 22mm and they measure as such but the clutch and throttle perches are not going on and I don't want to force them too hard. Prutser just wondering if you had to sand the ends down to mount allow the perches to slide on?
Don't sand the bars, open up the perch clamps.

The class tool is an HVAC tubing expander, ideally a live one rather than the hammer-in one.
Plaka is offline   Reply With Quote