View Single Post
Old 04-10-2013, 03:21 PM   #4
Life is a trip
gefr's Avatar
Joined: Nov 2005
Location: East Med, Greece
Oddometer: 3,704
These bolts run through the aluminum subframe.

So you can spray them or/and heat them from underneath. The reason they get too difficult is they are sprayed with mud from the rear wheel. Try cleaning them with a wire brush
Hope that helps.
There is always a reason!!
Fuel filters Fuel pump
Aluminum base plate for ITG foam air filter
Clutch master cylinder resleeving
Out of office 25 till 4th August
gefr is online now   Reply With Quote