While I'm here I may as well ask if someone could post a [B]simple[B] schematic drawing for wiring a set of MM10 lights to the Eastern Beaver PC8 fuse block on my 2006 Wee Strom, (DL 650). I ordered the lights with the wiring kit and switch. I am assuming I would cut the ring connectors and integral fuse off and wire this directly to the fuse block? As the PC8 is fused the included fuse would be redundant, correct? I will keep the relay and tap the dash mounted switch into a powered circuit, correct? Thanks in advance for any help. Doing the wiring is not an issue but I am a bit slow when it it comes to wiring diagrams.
Always keep an edge on your knife, son.