Thread: Clutch push rod
View Single Post
Old 04-15-2013, 12:19 PM   #4
gefr
Life is a trip
 
gefr's Avatar
 
Joined: Nov 2005
Location: East Med, Greece
Oddometer: 3,706
In the clutch slave culinder

You will have to unbolt the slave cylinder on the left side of the bike and install a washer in the end of the pushrod. However the liquid clutch assembly is there to compensate small changes by usint supplementary hydraulic liquid from the liquid tank. Are you sure you are not experiencing clutch slave cylinder failure?

http://advrider.com/forums/showthrea...171986&page=30
__________________
There is always a reason!!
Fuel filters Fuel pump
Aluminum base plate for ITG foam air filter
Clutch master cylinder resleeving
Out of office 25 till 4th August
gefr is offline   Reply With Quote