View Single Post
Old 04-15-2013, 02:02 PM   #30
Plaka
Brevis illi vita est
 
Joined: Jun 2010
Oddometer: 4,581
Quote:
Originally Posted by bmweuro View Post
Next week I will pull the heads off and check both rods and while I am in there I will go ahead and replace the bearings. The exhaust will come right off as I just installed them. Thanks for all of the suggestions.
I just replaced my big end bearings. I must have screwed up with the plastigauge because when I got my new bearings they were exactly the same thickness as the old ones. I mean dead on with a digital mic. And there was only the most trivial scoring in the old bearing too. I could have run them without issue. Grrr...I put the new ones in 'cause I had bought them and labeled the old ones and put 'em on the shelf.

Need a smokin' deal on some R100 big end bearings? Half price of new, precisely the same thickness.
Plaka is offline   Reply With Quote