View Single Post
Old 04-15-2013, 09:03 PM   #87
flemsmith OP
Joined: Apr 2006
Location: Apache Junction, Az
Oddometer: 720
Thanks, Greg!

Exactly the kind of input I was looking for. Not sure I can even grab the end of the float rod with side cutters, but I'm not too worried, worst case I can buy a new one with new floats and cut this one off with my dremel tool. The other inputs are quite helpful, will advise when I get some free time to actually correct them. It all appears quite do-able.

flemsmith is offline   Reply With Quote