View Single Post
Old 04-19-2013, 12:23 PM   #4
oldbmw OP
havehandlebarswillrideit
 
oldbmw's Avatar
 
Joined: Feb 2008
Location: Reedley, CA
Oddometer: 143
No reply.......

No reply from Pruster but I do have an idea. If you weld angle iron tabs on bottom of frame rails, you can remount your existing skid plate. A friend and I built a skid plate for a 1971 XS 650 I rode in the Barstow to Vegas Dual Sport event this past Thanksgiving. It took a beating but save my cases on a bike that had 3 inches of suspension travel. I think I will go this route. Then, the impact of rocks and boulders etc. don't transfer to the oil pan.
oldbmw is offline   Reply With Quote