View Single Post
Old 04-19-2013, 04:29 PM   #1
Half Fast OP
Gnarly lurker
 
Half Fast's Avatar
 
Joined: Jan 2007
Location: PA
Oddometer: 287
Broken tap or drill bit

When drilling or tapping a hole, what are the options for removing a broken drill bit or broken tap that is stuck in the hole?

I just finished a project that involved lots of new threaded fasteners and each time I held my breath thinking "Man, if I break this tap/bit I'm screwed". All went well but what to do if the worst happens?
Half Fast is offline   Reply With Quote