View Single Post
Old 04-24-2013, 05:45 PM   #844
PineyMountainRacing
Oops....
 
PineyMountainRacing's Avatar
 
Joined: Jul 2008
Location: SW Florida / Western NC
Oddometer: 1,890
Quote:
Originally Posted by hyperboarder View Post
The rear on the 800 is 20mm, I'd expect the front to be within about 3mm of that.
Well, the tool as it sits will do the rear, as it's a 20mm rod. If the front is 3mm smaller, then the 17 mm adapter would be ideal. If the front is 17-18-19, you could turn the 20mm rod down to 17-18-19 and it will be fine. Then either use it that way, or shim it back to 20mm with duct tape, electrical tape, etc. when you did the rear. The tool also has a sleeve that shims the rod out to 25 mm. You could turn the 20mm rod down to 17 and still use it for the 20mm rear. I suspect it would work even with a little slop.

But you know what they say, " a guy can never have too many adapters....."

PineyMountainRacing screwed with this post 04-27-2013 at 06:31 PM
PineyMountainRacing is offline   Reply With Quote