View Single Post
Old 04-28-2013, 08:48 AM   #6
Twilight Error
Going nowhere slowly
 
Twilight Error's Avatar
 
Joined: May 2002
Location: The Submarine Mines
Oddometer: 22,539
If you're going to try the drill and EZout route, use a transfer punch to mark the center of the bolt for drilling. McMaster has metric transfer punches - measure the head of the broken bolt and buy that size. When you do get in there with the ezout, heat the swingarm to help soften the loctite and expand the aluminum around the bolt. I'd use a heat gun instead of a torch, the temperature can be set lower and less likely to disturb the temper of the Aluminum than a flame.
Twilight Error is offline   Reply With Quote