View Single Post
Old 05-01-2013, 08:36 PM   #1
beergut OP
Thumper
 
beergut's Avatar
 
Joined: Dec 2009
Location: Indiana
Oddometer: 417
KTM 950/990 rotopax mounting plate

With lots of discussion and development, finally, a mounting option for Rotopax containers has been developed for the stock KTM 950/990 Adventure pannier racks.

This is the rack system these are designed for


Mounting plates are built using 3/16" 5052-H32 aluminum, in raw finish.



Bolts have been recessed as the photo above shows



Mounting design has been fully tested in Moab with full fuel containers








Can be used with dry bags


Mounting hardware
*a note on the mounting hardware*

Mounting hardware is quality stainless steel used with a locking nut. (wont rust) I believe this is a superior design ready for abuse.

It seems there is a slight difference between the 990/950 H&B pannier rack. The top bolt touches the rear fairing slightly on a 950. To me this is not an issue, to others it might. A smaller bolt would solve the issue.. I will leave that to the discretion of the buyer.


Current inventory ready to ship


Pricing

US freight:
$53/ea delivered via USPS
$93/pair delivered via USPS

International shipping:
$81/ea delivered flat rate USPS
$121/pair delivered flat rate USPS

Please contact me for my paypal address.
__________________
My KLR

DIY rear top rack

beergut screwed with this post 06-24-2013 at 01:28 PM
beergut is offline   Reply With Quote