View Single Post
Old 05-02-2013, 06:08 AM   #1518
SS Blowhard
Rucksta's Avatar
Joined: Oct 2008
Location: Gold Coast
Oddometer: 2,708
Originally Posted by DiabloADV View Post
Here's my conversion to single muffler. Next up is to weld the mounting tabs to the subframe and bolt the muffler in place. Then finish the hookup to the crossover I made.
Conventional wisdom says the cross over increases efficency by allowing the cylinders to share the mufflers, increasing the muffler volume available to each cylinder.

Why are you adding a crossover to a single muffler design?
Am I misunderstanding your use of "cross over" and you mean the same as junction box or "Y" pipe?
My bike is slow but the earth is patient.
Rucksta is offline   Reply With Quote