View Single Post
Old 05-14-2013, 11:08 AM   #95
vintagespeed's Avatar
Joined: May 2011
Location: Rancho Cucamonger, CA
Oddometer: 1,713
yeah.....matt go over your bike again and do as the others have said & replace the bearings seals in the hubs. (front & rear is probably a good idea) i'd also suggest lubing your swingarm bearings & linkage, they're pretty dry from the factory.

also, fix anything that you dont want to be tearing your flesh open in a get-off. like those ubolt deals....not good man. trim any zip ties flush, long bolt ends, wire, anything sharp that might bite you or your gear.
'12 Triumph ST3R corner raper (sold, sadly), '09 HusaBerg FE570 (also sold) and a bunch of 2 strokes that you dont want to read about. :)

vintagespeed is offline   Reply With Quote