View Single Post
Old 05-16-2013, 01:23 PM   #102
kirkster70 OP
moto junkie
 
kirkster70's Avatar
 
Joined: Aug 2008
Location: Virginia
Oddometer: 1,905
This is the gasket I will now be using on KP3 bags. It is also made by Trim-lok, just like the gasket on the KP2s. It is also a high-quality EPDM rubber.

I had a customer with some water infiltration issues, so a redesign was in order. Post one, paragraph one I speak about being big on customer service. That's not just idle talk to me. If anyone has any issues, please let me know and I will work with you to get it sorted to your satisfaction.

I will still use the other gasket when the lid overhangs the lower (KP2). When the lid is flush with the lower (KP3), a reverse flange will be bent in the lower, and this gasket will be used. There is nothing wrong with the other gasket - I was just using it improperly for a flush KP3 lid.

So......


Three recent customers stand out with a KP2 gasket on a flush KP3 lid ; Mike, Brent and Antonio. I'm doing a preemptive recall if you will. You have your choice of a 50% refund, or a new build. I will need the current bags / topbox back if you decide on a rebuild. If I have missed anyone, please pm me.





Joel's bags assembled and ready to mount...








kirkster70 screwed with this post 05-16-2013 at 01:55 PM
kirkster70 is offline   Reply With Quote