Originally Posted by WayneC1
Gravelseeker it is a little bit of a beast of a box to connect 10 items, screw connectors can be good, I use them for heated grips but the wire sizes on the IMO wiring is far thicker than it needs to be for low power / sensor circuits
With the battery it does look like a CR Series, there are sockets available from electronics stores for them to avoid soldering which you could consider
The battery just sist under a clip I think so no need to solder, but it's separating the top and bottom printcards to ge to the battery that put me off it.
And it's not the screw part that's the problem, the whole brown contact slips off the bracket/ card