Thread: DR350 Thread
View Single Post
Old 05-20-2013, 06:51 AM   #15927
Greg Bender
Beastly Adventurer
 
Joined: Oct 2007
Location: Cave Creek, Arizona, United States
Oddometer: 1,146
Quote:
Originally Posted by Schneiderman View Post
I was trying to remove the case saver bolts in order to re-install the front sprocket guard that the PO had removed, but included with the bike when I bought it. The lower case saver bolt snapped... Upper one did not give me any problem.

Is there anything important I need to know about that lower bolt before I take an ez-out to it?
No, although - personally - I would never, ever use an easy out. Instead, I would weld a nut onto it and remove it that way. In my experience, an easy out is a good way to make a bad situation much worse. YMMV.

Regards,

Gregory Bender
Greg Bender is offline   Reply With Quote