View Single Post
Old 05-30-2013, 04:10 PM   #565
Yardstick
Hydrophobic
 
Yardstick's Avatar
 
Joined: Oct 2007
Location: Chandler, Arizona
Oddometer: 2,962
Quote:
Originally Posted by justlookin View Post
...The only way I can get the light low enough to be useful is to put the mask on the lower mounting pins and space the top of the mask 2+ inches away from the fork. I am assuming that I can not invert the light because I need the relief cut in the heat sink to clear the voltage regulator - any ideas?

It sounds like you are missing the extenders for the fork mounts. It should look like this:



I don't think the orientation of the rear part of the light matters, but I could be wrong.
Yardstick is offline   Reply With Quote