View Single Post
Old 06-18-2013, 03:25 PM   #12
TINK OP
Studly Adventurer
 
Joined: Nov 2007
Location: So Cal
Oddometer: 668
quick check for rod bearing damage

Thanks Bill. checking the oil filter for flakes is definatly on the agenda, will report back. I figured the rod bearing would be the first to suffer, we'll see... fingers and toes crossed.
TINK


Quote:
Originally Posted by Bill Harris View Post
With the low suggested torque value of the oil pump cover bolts the thicker "wrong" o-ring won't compress enough leaving you with too much clearance in the oil pump and low HOT oil pressure. Not optimum, but over the short time that you ran it, there was probably little or no damage. You caught the problem early, good for you. BUT if anything was damaged, it would have been a rod bearing, which is easy to check and inexpensive to replace. As a quick check, remove the oil filter, cut it apart, unroll it and read it-- shiny and/or coppery flakes are un-good.

--Bill
TINK is offline   Reply With Quote